Three-phase inverter system installer

How do you install a 3 phase inverter?

Insert the lock through the knob opening and lock. The inverter is typically mounted vertically, and the instructions in this section are applicable for vertical installation. Some three phase inverter models can be installed horizontally (above 10° tilt) as well as vertically, and at any tilt over 10° up to 90°.

Do three phase inverters need neutral connection?

In most countries, three phase inverters require neutral connection at all times. In some countries, the three phase inverters can be connected to delta grids; in other cases, multiple single phase inverters can be used. Prior to system installation, refer to:

How do you connect a 3 phase inverter to a circuit breaker?

Use a five-wire cable for three phase connection.The maximum wire size for the input terminal blocks is 16 mm2. Turn OFF the AC circuit breaker. Release the six Allen screws of the inverter cover and carefully move the cover horizontally before lowering it.

What type of cable do I need for a 3 phase inverter?

For the SE10KUS, SE20KUS, SE33.3KUS three phase inverters where opposite polarity DC conductors are routed in the same conduit, 1000V rated cables must be used. This inverter is provided with an IMI (Isolation Monitor Interrupter) for ground fault protection. The symbol appears at grounding points on the SolarEdge equipment.